Designing a Bondage Table II

 The original table was 74 in long and 20 inches wide, with the end for the head being about 15 inches. It was made out of ½ in plywood (see drawing on the left). These dement ions did not allow the legs to be spread as long as I would like, so the new design was to be 36 in wide so ankles can be opened up to 30 inch apart and rather the on piece the top will be 2 duplicate pieces attached with hinged support. This will allow many more tie points and ability to add adjustable harnesses and shelves to hold arms thigh, etc (see right drawing). It will also help to break down to make more transportable.

 We have decided to use ¾ in plywood on a frame to make stronger and also allow add more hardware to make more adaptable. I am working on the supports but if goes as I hope, the table will function for standing bondage (like a St Andrews Cross), a flat table with all the slots and holes as tie points, an adjustable incline table and even a horse (see drawings).

 We are in the designing phase of this project and want your input, please look over the drawings, see what you like, what you would change, or would want to add. Our hope is to design a functional, useful piece of furniture that will be easy to setup and fun to use.

Please email any us with comments or ideas